Where should you put a stop loss in crypto futures?
A stop loss belongs at the price that proves the trade idea wrong — just beyond the zone the trade is based on — at a distance that fits normal volatility, and always well before liquidation. A common volatility rule for a long is stop = entry − k × ATR, and the loss when it fills = stop distance + round-trip fees. Example: a long from 60,000 with an ATR of 600 and k = 1.5 puts the stop at 59,100, a 1.5% stop; with a 0.06% taker fee each way, hitting it loses 1.5% + 0.12% = 1.62% of the position, $162 on $10,000, and at 10x liquidation is less than 10% away, so the stop comes first.
Start from the price that proves you wrong
A stop is not a pain threshold; it is the price at which the reason for the trade no longer holds. If a long is based on a support zone, the stop goes just beyond that zone, not inside it. If it is based on an order block or the low of the value area in a volume profile, the stop goes past the far edge of it. Price often probes a zone before turning, so a stop placed exactly on the line is hit by ordinary noise.
Obvious levels — round numbers, the exact low of the last candle — collect many stops in the same place, which is why price often runs through them by a small margin before reversing. Placing the stop a little beyond the zone, rather than on the obvious tick, reduces that. Which zone matters is the setup's decision; how to choose the entry inside it is covered in how traders find an entry point.
Size the distance against volatility (ATR)
The Average True Range (ATR) measures how far price normally moves per candle on your timeframe. A volatility stop for a long is stop = entry − k × ATR; for a short it is entry + k × ATR. In the example, an ATR of 600 on a 60,000 entry is 1% of price, and k = 1.5 puts the stop 1.5% away at 59,100.
Traders commonly test k between about 1 and 3; there is no value that is right for every market or timeframe. The useful check is the other direction: if the structure-based stop is much closer than one ATR, ordinary movement is likely to reach it. Compare fees with ATR too — here the 0.12% round trip is 12% of one ATR. On short timeframes, where ATR is small, that share grows fast. ATR itself, and stops from 1 to 3 ATR side by side, are in ATR stop loss: formula, multiples and fee check.
Always before liquidation
Your margin is the notional value divided by leverage, so a price move of 100 ÷ leverage percent against you uses up all of it. Maintenance margin and fees make liquidation happen sooner than that. At 10x, liquidation on a long from 60,000 is less than 10% away — above 54,000. At 50x it is less than 2% away, and maintenance margin can leave less room than a 1.5% stop needs.
If the stop sits beyond the liquidation price, the exchange closes the position first and may charge a liquidation fee on top — see crypto futures liquidation fees. On cross margin the whole balance backs the position, so liquidation moves further away but more of the account is at stake — see isolated vs cross margin.
What the stop really costs when it fills
The loss at the stop = stop distance + round-trip fees + slippage. A stop-market order fills as a taker, so use the taker rate for the closing side; in a fast move it can also fill past the trigger price (slippage vs trading fee). A stop-limit order controls the price but may not fill at all when price gaps through it.
The tighter the stop, the larger the share fees take. On a 0.3% stop the same 0.12% round trip is 28.6% of the total loss at the stop. A tight stop is not wrong, but its real cost is higher than the chart distance suggests.
Then size the position from the stop
The stop sets the distance; the position size sets how much money that distance costs. Choose the stop first, then the size, so that a stop-out loses the amount you planned — see how to calculate position size with fees. Once the trade has moved your way, the fee-aware place for a protective stop is covered in moving your stop to break-even.
On your chart: Market Compass and Cost Compass
Market Compass is a TradingView indicator from loweef that draws a volume profile with point of control and value area, and order blocks from confirmed market structure — the zones a structure-based stop is placed beyond. Cost Compass shows your break-even after fees, how far it sits in percent and in ATR, and an approximate liquidation price, so you can see whether a stop is wide enough and still inside liquidation. Both are part of the Compass series. They show zones, states and estimated costs; they do not tell you when to buy or sell. Access is free right now and granted on request: send a private message to loweef on TradingView with your TradingView username. You do not need a loweef account to get access.
Fees are part of the math
Every stop-out pays two fees, so lower fees shrink the real loss of every stop you take. With a 70% fee rebate (the Toobit rate through loweef) the 0.12% round trip nets 0.036%. The exchange still charges the full fee when the stop fills; the rebate arrives afterwards. Check how much your fees would return.
Limits
The liquidation figures are upper bounds from margin and leverage only; your exchange's liquidation price includes its maintenance margin tiers and fees and is the number to use. This page explains arithmetic. It is not financial advice and does not tell you when to buy or sell.
Frequently asked questions
Should I put my stop loss on a round number?
Usually just beyond it. Round numbers and obvious lows collect many stops, and price often runs through them by a small margin before turning. A stop a little beyond the zone the trade is based on avoids being taken out by that probe.
How many ATR should a stop loss be?
There is no single right multiple. Traders commonly test about 1 to 3 ATR on their own timeframe. The point is that a stop much closer than one ATR is likely to be reached by ordinary movement.
Does leverage change where the stop should go?
No. The stop comes from the chart. Leverage changes the margin you post and how close liquidation sits, so higher leverage leaves less room between the stop and liquidation.
Stop-market or stop-limit for a stop loss?
A stop-market order exits once triggered but pays the taker fee and can slip. A stop-limit controls the price but may not fill if price gaps through it, which leaves the position open.
Related terms
Related questions
- Moving your stop to break-even? Add the fees first
- How to calculate position size in crypto futures (leverage and fees included)
- How do traders find an entry point in crypto futures?
- How much is the liquidation fee on crypto futures?
- Is slippage a trading fee, and how does it compare with the taker fee?
- How much does a guaranteed stop-loss cost on crypto futures?
- ATR stop loss for crypto: formula, multiples and fee check
- Where can you see the trading fees you have paid on an exchange?
Last checked: 2026-10-28